Round Clematis Tutorial 3

Round Clematis Tutorial 3


┬áRound Clematis Tutorial 3, in which I cover steps 11 – 14 including foiling, flat soldering, outer lead attachment, final soldering and applying the patina.

Step 11

Round Clematis Tutorial 3 step 11

I am now starting to foil the pieces, I do this by removing them one at a time and then replacing them as I proceed. I find this method works very well as you are able to make minor adjustments as you work across the panel. It is important during this process to make sure you burnish the foil onto the edge of the glass. I always use a putty knife for this process.


Step 12

Round Clematis Tutorial 3 Step 12

Here is the panel with all the foiling complete. I will now proceed to flat solder the panel on the front side. I use 50/50 solder to do this if I have any, if not 60/40 will do. Once the front face has been flat soldered, remove the template and repeat the process on the reverse. I use a “U” shaped lead came to provide a nice neat finish to the outside edge of the panel.


Step 13

Round Clematis Tutorial 3 step 13

First soldering completed on both sides and the perimeter lead in place. You can see the two pieces of black tape securing the ends to the panel. It’s always good practice to place the join on a seam for neatness. The final bead solder can now take place to finish the panel.


Step 14

Round Clematis Tutorial 3 step 14

Once the bead soldering is complete all flux and solder residue should be removed. I would use hot water and a little detergent for this, then clean with” 0000 ” steel wool. This will make the patina take a lot better. Finally, I use a little black stove polish on a brush to buff up the finished panel.

Links:

Click here to download PDF pattern

Round Clematis Panel: