Slade Poppies ( Initial Stage )

 

Slade Poppies ( Initial Stage )First Cuts


There is never a particular place for starting to cut out the glass for a project. With this panel I began by first cutting the leaves and soil pieces at the bottom of the panel. I was fairly confident with my glass choices here, using a  Youghiogheny stipple glass 4117 SP green, ice white, bluish grey was for the leaves and a granite backed Uroboros 65 – 17 light & dark browns for the soil pieces. The spaces for the seed pods have been left empty at this stage as I will add them later when I have a better idea of the finished panel.


Slade Poppies top and bottom sections

 

The top and bottom background pieces were then cut from the whole sheet of Uroboros 10 – 16 light & dark browns, turquoise with mini fractures. This is can be tricky even with the use of a band saw so worth taking your time over. The two sides have worked out fine but the middle piece has broken off in slightly the wrong place. These things happen which means I will have to adjust the pattern slightly by moving a couple of the flowers.

Slade Poppies ( Initial Stage ) Adding The Flowers



Slade poppies adding the flowers

With the first of the flowers cut I am able to position them on top of the background glass. I then mark around them using a fine permanent marker. The background can now be cut away using the band saw, leaving a perfect fit for the flower. This can be a slow process but the advantage is I am able to build up the image as I go. The glass used for the poppies is Uroboros 60 – 25 red & orange with white.

Slade Poppies flowers adjusted
Here I have managed to re-position the two flowers in the middle of the panel. This completes the top and bottom sections leaving the central part to do. However now everything is back on track I am feeling confident of a successful outcome.

Here is a link to Youghiogheny Glass, well worth a look at their fabulous website : https://www.youghioghenyglass.com/